Rocktron Replifex - Manual (Page 26)

23
The Tremolo effect continuously varies the volume of the signal.
The PARAMETER SELECT control will allow you to access each of the following
Tremolo parameters:
Functions and Parameter Descriptions
TREMOLO
Function
TREMOLO I/O
LOCATION
TREM DPTH
TREM RATE
SHAPE
TIME
The TREMOLO I/O parameter determines whether the tremolo circuit
is active or bypassed for the current preset.
The LOCATION parameter determines whether the Tremolo is located
Pre-Reverb or Post-Reverb. Most vintage amplifiers used the tremolo in
a Post-Reverb configuration.
The TREMOLO DEPTH parameter determines the amount of modula-
tion for the Tremolo signal. Lower DEPTH settings produce more
subtle tremolo effects, while higher settings will result in a more
extreme tremolo effect.
The TREMOLO RATE parameter determines the speed at which the
tremolo signal modulates (or increases and decreases in volume).
The SHAPE parameter determines the waveshape of the tremolo signal.
Selecting a different waveshape produces a different tremolo effect.
The TIME parameter determines the multiplier by which a new
modulation rate will be selected for the RATE parameter when the Tap
Delay feature of the Replifex
™ is used. (See Section 7: "Tap Delay" for
more information on the Tap Delay feature.)