Rocktron Replifex User Manual

Page 40

Operating the Replifex

™

Switching Channels on Amplifiers and Preamps via the Replifex

The Replifex

allows you to switch channels on an amplifier or preamp by connecting a RTS cord from

the "CHANNEL SWITCH" jack on the rear of the Replifex

to the "FOOTSWITCH" jack on the remote device(s).

A single stereo-to-dual mono cord can also be used to connect from the Replifex

to two separate units. This

allows for channel switching to be programmable (i.e. switched automatically when a Replifex

preset is

recalled) instead of having to use a latching footswitch each time a channel needs to be switched. This

function can also be performed through programming a continuous controller to the CHAN SW parameter(s).

See page 41, "Controller Assignments" for more information on assigning continuous controllers.

Step 3

Use the PARAMETER ADJUST control to select the on/off condition of Channel Switch 1.
When switched "ON", the channel connected to the Tip of the Replifex

™

CHANNEL

SWITCH jack will be switched when the current preset is recalled.

CHAN SW 1

Step 2

Turn the PARAMETER SELECT control one step clockwise to "CHAN SW 1".

CHAN SW 1

OFF

Step 1

Turn the FUNCTION SELECT control to "CHANNEL SWITCHES".

CHANNEL SWITCHES

4,7

2,5

3,6

The Tip of the "CHANNEL SWITCH" jack sends the change for Channel

Switch 1, while the Ring of the "CHANNEL SWITCH" jack sends the change

for Channel Switch 2. When Channel 1 is on, the Tip is connected to the

Sleeve. When Channel 2 is on, the Ring is connected to the Sleeve. When

Channels 1 and 2 are both off, the Tip and Ring are an open circuit with

respect to the Sleeve (see diagram).

SLEEVE

RING

TIP

Ch. 2

Ch. 1

* This feature was designed to operate with as many different amplifiers as possible. However, due to the large

number of amplifiers available on the market, it cannot be guaranteed to be compatible with all amplifiers.