Program changes – Rocktron Replifex User Manual
Page 52

49
Program Changes
Step 1
To access MIDI Program Mapping, turn the FUNCTION SELECT control clockwise until the
Replifex
™
displays "PROGRAM CHANGES".
Program Changes allow for different MIDI program numbers to be assigned to Replifex
preset
numbers. For example, MIDI program #58 can be mapped to Replifex
preset #34. Then, when program
#58 is selected from a MIDI transmitting device (such as a Rocktron All Access
foot controller), preset
#34 will be recalled on the Replifex
.
The Program Changes Map table is shipped from Rocktron at a one-to-one correspondance (i.e. MIDI
program #1 is mapped to Replifex
preset #1, 2 to 2, 3 to 3, etc.).
4,8
3,7
1
2,5,6
Step 2
Turn the PARAMETER SELECT control one step clockwise to display the current Program
Change On/Map/Off status.
PROGRAM CHANGES
PROG CHANGES
ON
Program Changes status options
ON - Execute MIDI program changes as received by a MIDI controller
MAP - Use mapping table when a program change is received
OFF - Do not execute MIDI program changes
Step 3
Turn the PARAMETER ADJUST control to select the desired Program Changes status
setting.
PROG CHANGES
MAP
Step 4
Press the STORE button to save the status selection. "STORED" will flash briefly on the
display.
STORED
Operating the Replifex
™