Rocktron Replifex - Manual (Page 21)

18
Compression is often used to maintain an even level when using clean tones,
and is also used to increase sustain when using high gain distortion.
The PARAMETER SELECT control will allow you to access each of the following
Compressor parameters:
Functions and Parameter Descriptions
COMPRESSOR
Function
The COMPRESSOR I/O parameter determines whether the compres-
sion circuit is active or bypassed for the current preset.
The COMPRESSOR THRESHOLD parameter determines the input
level (in dB) at which compression will begin. Lower settings of this
parameter will result in more compression.
The COMPRESSOR ATTACK parameter determines the speed (in
milliseconds) at which the compressor will reach its maximum com-
pression level after the input signal has exceeded the threshold level (set
by the COMPRESSOR THRESHOLD parameter).
The COMPRESSOR RELEASE parameter determines the speed at
which compression will cease after the input signal has dropped below
the threshold level.
COMPRESR I/O
COMP THRESH
COMP ATTACK
COMP RELEASE