dbx DriveRack PX Manual - Manual (Page 38)

• Turning the wheel will select the preset you wish to load at initial reset.
• Press the button again when the selection is complete. Normal resetting will
continue.
System Lock Out
• Press and hold at power-up until one of the following messages appears (depending
on the current state of system lockout):
System Unlocked All user input will be accepted to exit
or
System Locked! No user input will be accepted to exit
or
Filter Unlocked. Filter clear will be accepted to exit
Use the to select the desired state and then press the button to
continue booting in the selected state.
The “System Unlocked” state allows normal operation.
The “System Locked” state is the complete lockout state. No user button input of any
kind will be acted upon.
The “Filter Unlocked” state is the same as the “System Locked” state except that the
and buttons are accepted. Pressing once will go to the AFS edit
page with the “Clear” parameter set to “LIVE” and the cursor on the third parameter
“Clear w/ ”. Pressing and holding the button will enable a filter clear. After
the clear, the DriveRack PX will return to the preset screen.
Locked operations will cause a “LOCKED” icon to appear in the upper right corner of the
screen for a few seconds. •
•
•
•
•
DriveRack
®
PX
Section A
Appendix
®