dbx DriveRack PX Manual - Manual (Page 15)

AuTO-EQ WIzARD
Once you have completed the Setup wizard, you can now proceed to EQ your system. The
Auto-EQ Wizard automatically adjusts the response of the system by producing pink noise
and adjusting the Graphic EQ until the RTA matches a selected response. (The Auto-EQ
TM
Wizard can be initialized at any time by pressing and holding the button.) The
display will look like this:
DriveRack PX
Auto EQ WIZARD
to advance
Press the button and the display will read:
Connect mic to RTA
input. Press RTA
input button.
Auto EQ
The display is prompting you to connect an RTA-specific microphone to the front-panel
RTA XLR input, and press the button. It is recommended that you use the
included dbx M2 RTA microphone. The display will appear something like this:
MED
You can now select any one of the several different Frequency responses for the Auto-EQ.
The options are: Flat (0), and Responses A-D. You can also select Low, Medium and High
Precision. Press the to toggle between selecting Response and Precision.
Turn the to scroll through the available options. Once you have selected
your desired EQ Frequency response, press the button and the display will
appear as follows:
You will now proceed to “Pink” the room by adjusting the Pink level. The range of bar
graph is –INF to +20dBu. Be certain to raise the pink noise level to the level of loudness
intended during the performance. Once the Pink level has been adjusted to the desired
volume, press the button and the Auto-EQ sequence will begin. The display will
•
•
•
•
•
DriveRack
®
PX
Section 2
Getting Started
®