dbx DriveRack PX Manual - Manual (Page 14)

Press Select to Load
> New Preset
Load New Preset
Press the wheel to load the new preset. The display will look like this:
Connect mic to RTA
input. Press RTA
input button.
Auto Level
The display is prompting you to connect an RTA-specific microphone to the front-panel
RTA XLR input, and press the button. It is recommended that you use the
included dbx M2 RTA microphone, placed somewhere close to the middle of where your
audience will be. (If you wish to manually balance the individual speaker levels by ear,
you can skip the Auto Level portion of this wizard, by pressing the button.)
Once you’ve connected the RTA microphone and pressed the button, the
display will look like this:
Auto Level
You will now proceed to “Pink” the room by adjusting the Pink level. The range of
bar graph is -Inf dB to +20dB. Be certain to raise the pink noise level to the level of
loudness intended during the performance. Once the Pink level has been adjusted to the
desired volume, press the button and the Auto Level sequence will begin. The
DriveRack PX will adjust balance levels for your main speakers (and your subs, if you have
them). Note that you may be prompted to readjust the your speaker knob settings. When
the Auto Level sequence is finished, the display will look like this:
Auto Level Complete
Release RTA INPUT
button to exit.
After you press the button to release it, the display will look something like
this:
EON10g2wSub Loaded
and levels balanced.
-Auto EQ
Press the button to start the Auto-EQ wizard.
•
•
•
•
DriveRack
®
PX
Section 2
Getting Started
® 0