Pitney Bowes E702 - Manual (Page 40)

E 7 0 0 / E 7 0 2 M E T E R S
40
does not display
1. ZIP code not installed or inspection required. Press Refill and enter
$0.00 to allow Pitney Bowes to install your ZIP.
2. Out of ink. Use function to
install a new ink cartridge.
You do not have enough money in your account at the Data Center to
pay for the refill amount. Perform refill procedure for smaller
amount or contact Pitney Bowes to add to
your account.
No ZIP has been installed in the meter by the Data Center. Perform a
refill to install the ZIP. Press
Refill . If you do not want to add
funds at this time, set the refill amount to $0.00.
Data Center connection could not be made. Repeat call. It may have
been a busy signal. If unsuccessful, check the Pitney Bowes Phone
Number and any dialing prefix you may have added in the
Setup Option.
The card is inserted incorrectly. Remove card and reinsert with the
gold circle face up and toward the bottom.
Data Center was disconnected before the refill transaction completed.
Press
yes to repeat the call.
A busy signal was detected. Repeat call. If unsuccessful, check the
Pitney Bowes Phone Number and any dialing prefix you may
have added in the
Setup Option.
An incorrect lock code has been entered. Press Clear ( C ); key in code
again. If you cannot remember the correct code, call Pitney
Bowes.
No refill has been performed for 90 days. Press Refill . If you do not
want to add funds at this time, set the refill amount to $0.00.
INSPECTION DUE-REFILL REQUIRED
INCORRECT CODE
CHG PB PHONE #
DATA CENTER PHONE IS BUSY
CONNECTION LOST-TRY AGAIN?
CANNOT READ CARD
CHG PB PHONE #
CANNOT REACH DATA CENTER
CANNOT FIND ZIP - REFILL REQUIRED
ACCOUNT BALANCE LOW
INSTALL INK CARTRIDGE?
READY