ParkZone PKZ1980 - Manual (Page 11)

11
EN
Control Surface Travel Measurement
Control Surface Travel Information
Note: Measurements are made at the widest point of each
control surface from the neutral position for each control
surface.
Note: These settings have a tolerance of plus or minus 1mm.
Factory Setting for Control Surface Travel
Factory settings for the DX5e transmitter are Dual rates set at
100% on high rate and at 70% on low rate. These dual rates
cannot be changed on the DX5e. All controls surfaces are set
for 100% adjustable travel volume (ATV).
The factory settings provide a moderate amount of control
surface movement. The pushrods come installed in the
outermost holes of the servo arms. Clevises come installed in
the outermost holes of the control horns (away from the control
surface).
Neutral: 0 mm
Low Rate: 8 mm
High Rate: 11 mm
Aileron
Neutral: 0 mm
Low Rate: 9 mm
High Rate: 13 mm
Elevator
Rudder
Neutral: 0 mm
High Rate: 14 mm
Low Rate: 11 mm
Factory Setting for Rudder and Elevator
Servo Arms and Pushrods