Set control board for push-to-open, Step 1, Step 2 – Mighty Mule FM350 User Manual
Page 37: Step 3, Step 4, Step 5, Stall force

33
rev 07.16.12
1
ON
23
4
15
CHARGING
POWER
STATUS
RF
PULL-PUSH
MODE1
MODE2
LOCK/BEACON
OFF
120
MIN
MAX
STALL FORCE
CLOSE TIME
SET
LIMIT
LEARN
REMOTE
AUX OUT
SOLAR
PANEL
18VAC
RCVR
GRN
BLK
RED
EXIT
SAFETY
EDGE
CY
CLE
COMMON
LINK
1
ON
23
4
PULL-PUSH
MODE1
MODE2
LOCK/BEACON
Set Control Board for Push-To-Open
Make sure the control box power switch is OFF. Use a small
screwdriver to move the Number 1 DIP switch from the
factory setting (OFF / Pull-To-Open) to ON for Push-To-Open.
Turn power switch ON. The control board is now configured
to push the gate open.
Setting the Open Position Limit (Push-To-Open Installations)
Step 1
Power switch is on,
gate is in the CLOSED
position, opener arm fully
retracted.
Step 2
Press the transmitter to
activate opener arm. The
gate will begin to OPEN.
Step 3
When the gate reaches
the desired OPEN
position, press the
transmitter to
stop the gate.
1
ON
23
4
15
CHARGING
POWER
STATUS
RF
PULL-PUSH
MODE1
MODE2
LOCK/BEACON
OFF
120
MIN
MAX
STALL FORCE
CLOSE TIME
SET
LIMIT
LEARN
REMOTE
AUX OUT
SOLAR
PANEL
18VAC
RECR
GRN
BLK
RED
EXIT
SAFETY
EDGE
CY
CLE
COMMON
LINK
MIN
MAX
STALL FORCE
Step 4
With the gate at the
correct position,
program the open limit
setting by pressing and
holding SET LIMIT for 5
seconds.
Gate in Closed
Position
Gate
Opening
Gate
Opened
ON/OFF
Step 5
Press the transmitter
again to allow the gate
to return to the fully
CLOSED position.
Gate is now
programmed
The gate open position is now programmed.
If you set the limit at the wrong position: press
your transmitter to return the gate to the fully
closed position, then press and hold the SET LIMIT
button for 5 seconds. This will clear the memory
for the open limit position. Repeat Steps 1-5.
Gate in Closed
Position
Gate open position
is now programmed