Mighty Mule FM350 - Manual (Page 22)

18 rev 07.16.12
At this stage of the installation, the opener should be installed on
the gate and the closed position stop plate should be in place.
Check List
• The gate is plumb, level, and swings smoothly on its hinges.
• A plate or support was added for the gate bracket (if necessary).
• The opener is level and mounted on the centerline of the gate.
• All hardware is tightened at this time.
Gate Swings Evenly and Freely
Hung Firmly and Plumb
1. KEEP CLE AR! Gate may mo ve at a ny tim e.
2. Do not al low c hild ren to op erate gate o r
play in ga te area . 3. This gate i s for vehi cles only. P edest rian s
must us e a s epara te en tranc e.
Moving Ga
te Can Ca use
Injury Or Dea
th
WARNING !
Horizontal Cross Member
Single Gate Opener
Post Bracket Assembly
Gate Bracket
Closed Position Stop Plate
Preparing to Activate the System
In order to have easy access to the control board during the rest of the
installation, remove the opener and remount it upside down.
Bottom
Access Panel
ON OFF
ON/OFF
Switch
IMPORTANT:
Return the opener arm to the
upright position when installation is
complete to prevent water damage
to the control board.