Mighty Mule FM350 - Manual (Page 29)

25 rev 07.16.12
Setting the Closed Position Limit
ON/OFF Turn the power switch on
to the ON position
For PULL-TO-OPEN Installation
Step 1
Power switch is on, gate
is in the OPEN position,
opener arm fully
retracted.
Step 2
Press the transmitter to
activate opener arm.
The gate will begin
to CLOSE.
Step 3
When the gate reaches
the desired CLOSED
position, press
the transmitter
to stop the gate.
Step 4
With the gate at
the correct position,
program the closed limit
setting by pressing and
holding SET LIMIT for 5
seconds.
Gate in
OPEN
Postion
Gate
Closing
Gate
Closed
Gate in
OPEN
Position
ON/OFF
Step 5
Press the transmitter
again to allow the gate to
return to the fully
OPEN position.
The gate closed position is now programmed.
If you set the limit at the wrong position: press your
transmitter to return the gate to the fully opened
position, then press and hold the SET LIMIT button
for 5 seconds. This will clear the memory for the
closed limit position. Repeat Steps 1-5.
1
ON
23
4
15
CHARGING
POWER
STATUS
RF
PULL-PUSH
MODE1
MODE2
LOCK/BEACON
OFF 120
MIN MAX
STALL FORCE
CLOSE TIME
SET
LIMIT
LEARN
REMOTE
AUX OUT
SOLAR
PANEL
18VAC
RECR
GRN BLK RED EXIT
SAFETY
EDGE
CY
CLE
COMMON
LINK
MIN MAX
STALL FORCE
SETTING THE CLOSED POSITION LIMIT