Luxul XWR-600 - Manual (Page 10)

10
XWR-600
a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | luxul.com | 801-822-5450
LUX-UG-XWR-600 Vers: 07814
w
Secondary DNS: Allows you to select the checkbox and manually configure a
Secondary DNS Server IP Address. “DNS Assigned By ISP” is the default setting
w
Custom MAC Address: Allows you to set a Custom MAC Address which allows
the Router to appear as a Computer to the ISP Modem. Some Modems will cache
the MAC Address of the first device used to setup Internet Service and cannot be
reset by the user. If this occurs you can clone that setup Device’s MAC Address to
allow the XWR-600 to connect to the Modem.
w
Custom MTU: Allows you to configure a Custom MTU setting. MTU (or Maximum
Transmission Unit), is the maximum packet size allowed on the network. Some ISPs
(usually DSL or Fiber) will require this value to be set if the Modem is in
Bridge mode.
„
After making any changes to the Connection Type, you must click the Save button
to Save your changes, then you must click the Reboot button for the changes to take
effect. You can click the Save button and proceed to other pages without losing your
configured changes.
3.1.2 Connection Type PPPOE
This Connection Type option requires a Username and Password that is provided by the
ISP and is typically used on Bridged DSL Modem connections. This type will automati-
cally pull the WAN IP, WAN Subnet Mask, WAN Gateway, WAN Primary
DNS and WAN Secondary DNS from the ISP’s Modem once the Router is
successfully Authenticated.
Select the Menu Quick Setup and Connection Type PPPOE from the dropdown to
view the following page: