LINK Systems Omni II Automatic Setups Module - Manual (Page 34)

October 16, 2008 Manual Version 1.1
4-6
cushions. Slot AS5 controls hydraulic overloads. {Hydraulic Overload trip point control is
currently unavailable}. In Figure 4.3, slot AS1 has already been assigned for control of a
counterbalance. If it is necessary to add, change, or modify an Air Slot assignment, move the
cursor to the Air Slot to be modified and press the CHANGE SETTING softkey. A list of
available assignments for the Air Slot will appear. Move the cursor to the desired assignment
and press the SELECT softkey.
After a control function has been assigned to an air slot, the system must be configured. This
configuration sets parameters, such as minimum air pressure, maximum air pressure, and
tolerance limits. The number and types of parameters will depend upon the function assigned to
the air slot. To configure a particular air system, move the cursor to that system and press the
CONFIGURE SYSTEM softkey.
Section 4.2.1.1 Configuring Counterbalance Systems
The counterbalance configuration screen is shown in Figure 4.4.
Stroke
Mode Inch
Drive
Speed
Stroke
Speed
SPM
SPM
0
0 Order
Counter
PC STATUS
Counter OFF
EXIT
0 0
Program/Run Switch
TOP
Auto-Setup
Config Counter-Balance 1 Configuration
Module:
Air Slot:
Mode:
Display Weight As:
Max. Die Weight:
Min. Die Weight:
Max. Pressure:
Min. Pressure:
Tolerance:
Fault Time:
Transducer Full Scale
Parameter Help
CHANGE
SETTING
1
1
ON
lbs
8500 lbs
0 lbs
75 psi
25 psi
2 psi
20 seconds
200 psi
System not used.
System will go to setpoint and job recalls
will change the setpoint.
System will go to setpoint but job recalls
will not change the setpoint. OFF
ON
MANUAL
-
-
-
Figure 4-4 Counterbalance Configuration
The editing cursor indicates which parameter is currently selected. Softkey 1 (the uppermost
vertical softkey) will change its description based on the parameter and, when pressed, allows the
currently selected parameter to be changed. The up and down arrow keys move the editing
cursor from one parameter to another. See Appendix A for examples of setting up each kind of
system. The features of this screen are:
Help The
“Help” box at the bottom of the screen changes depending on the