LINK Systems Omni II Automatic Setups Module - Manual (Page 12)

October 16, 2008 Manual Version 1.1
2-6
SPM
SPM
0
0 Order
Counter
PC STATUS
READY TO STROKE
Counter OFF
Auto
Setup
CHANGE
NUMBER
SPM
SPM
0
0 Order
Counter
PC STATUS
READY TO STROKE
Counter OFF
Auto
Setup
SUPPLY
ACCESS
CODE
SPM
SPM
0
0 Order
Counter
PC STATUS
READY TO STROKE
Counter OFF
Auto
Setup
CHANGE
NUMBER
SPM
SPM
0
0 Order
Counter
PC STATUS
READY TO STROKE
Counter OFF
Auto
Setup
SELECT
STEP A: SELECTING PARAMETER TO BE CHANGED STEP B: SELECTING USER NAME
STEP C: ENTERING USER PASSWORD STEP D: CHANGING PARAMETER
PRESS SUPPLY
ACCESS CODE KEY
Slide Adjust #1 (ON)
Setpoint:
Actual
Shutheight
Fault:
Status:
None
In Position
20.000
20.000
in
in
Slide Adjust #1 (ON)
Setpoint:
Actual
Shutheight
Fault:
Status:
None
In Position
20000
20.000
in
in
SELECT A USER NAME
USER NUMBER ONE
USER NUMBER TWO
USER NUMBER FIVE
Setpoint:
Actual
Shutheight
Fault:
Status:
None
In Position
20.000
20.000
in
in
USER NUMBER ONE CODE _______
Slide Adjust #1 (ON)
Setpoint:
Actual
Shutheight
Fault:
Status:
None
In Position
20.000
in
in
Slide Adjust #1 (ON)
__.___
Figure 2-2 Example Password Entry
Step A: Select the restricted item. In the example shown in Figure 2.2 the restricted item is
Slide Adjust #1 setpoint. Once the parameter is selected then Softkey # 1, the upper
vertical softkey (Softkey # 1 is highlighted in Figure 2.2), will display the legend
“SELECT”.
Step B:
A list of users that have access to this restricted item will appear. In the example
shown in Figure 2.2 only User Number One, User Number Two, and User Number
Five have access to this restricted parameter. The system may have several more
users, but the three users listed on the screen are the only users that have access to
change an Auto Setup Setting. The user must use the arrow keys to position the
cursor on his user name. After placing the cursor on the correct name, the user must
press the SELECT softkey. The SELECT softkey must be pressed even if there is
only one user name displayed.
Step C:
The display will show the selected user name and request the user password. The
user must enter the correct password and then press the ENT key.
Step D:
Upon entry of the correct password, the user will be allowed access to the restricted
item. In the example shown in Figure 2.2, the user will have access to change the
Slide Adjust #1 setpoint.