Lingenfelter L250070709 Lingenfelter CTS-V LSA Supercharger Pulley 2009-2012 v1.9 - Manual (Page 24)

Page 23.
79. Install the boost solenoid bracket onto the
bypass valve actuator. Torque the bolt down to
89 lb-in (10Nm).
80. Reconnect the vacuum hose from the
bypass valve actuator to the supercharger.
81. Using a 10 mm socket, replace the inlet
air pressure sensor and torque down to 89 lb-in
(10 Nm).
78. Tighten the set screw so that it barely
touches the stop plate on the front cover. After
the initial contact, tighten the set screw 1/8 to
1/4 turn more to set the bypass valve blade
into position. The set screw should now be
touching the stop plate on the front cover. This
will prevent the bypass valve blade from getting
stuck on the front cover casting. Remove the
bypass actuator set tool.