Lingenfelter L250070709 Lingenfelter CTS-V LSA Supercharger Pulley 2009-2012 v1.9 - Manual (Page 18)

Page 17.
56. Apply a thin film of the supplied Permatex
Ultra Black Gasket maker to the mounting
surface of the front cover.
57. Insert the LPE provided dowel sleeves
(part # ETN337144 ) into the two (2) locations
on the supercharger by squeezing and twisting
them in with pliers.
58. Carefully place the supercharger front
cover on the supercharger. Make sure the
pins insert into the empty isolator coupler slots.
Using a 10 mm ratchet, torque down the six
bolts to 20 lb-ft (27 Nm).
NOTE: The torque pattern is not critical on this
component. As the snout is being pulled to
the supercharger, slight tapping with a rubber
mallet on the pulley will help seat the isolator
and allow it to spin freely.
55. Using a razor blade and Scotch pads,
scrape and clean the mounting surface of the
supercharger front cover.