Lingenfelter L250070709 Lingenfelter CTS-V LSA Supercharger Pulley 2009-2012 v1.9 - Manual (Page 23)

Page 22.
74. Insert the bypass actuator arm into the
supercharger front cover bracket. Replace the
PCV hose and correct vacuum hose as shown.
75. Use the set tool to set the actuator position
[tool part # ETN86063]. Place the actuator set
tool so that the actuator arm teeth are located in
the position shown. Note the bypass set screw
position.
NOTE: The front cover and bypass actuator
are shown off of the vehicle for illustrative
purposes only.
76. Hold the bypass stop plate back so that
the bypass valve blade is in the closed position.
The stop plate should not be touching the set
screw on the bypass actuator. The set screw
can be adjusted using a 3/32” Allen wrench.
77. Install the two (2) 10 mm bolts and torque
them to 21 lb-ft (28.5 Nm).
Stop plate on
front cover
Bypass set
screw