Laerdal SimMan 3G Mystic - Manual (Page 30)

27 28
Setup for Simulation
Warning: Connecting a full fluid fill unit to a manikin with a full
internal reservoir will result in system overflow. Blood will drain out
of the right leg. Repeatedly overflowing the system may damage
the product.
Fill Manikin Blood Reservoir
Note: Roll the right leg skin down to expose the fill panel.
1 Connect blood fill unit tubes to the blood and air connectors
in the right leg panel.
2 Push the fill button on the panel. The button will light up and
blood will flow into the manikin.
3 When the flow stops, disconnect the fill unit.
4 Push the fill button on the panel. The light will go out.
Note: Disconnect tubes from the manikin before pushing the fill
button. Pushing the button before disconnecting the tubes will
initiate draining of the tank.
Empty Internal Blood Reservoir
1 Connect an empty blood fill unit to blood and air connectors
in the right leg panel.
2 Blood from the internal reservoir will drain into the bottle.
3 When the flow stops, disconnect the blood and air connectors.
4 Mixing of Blood and Fluid
To simulate clear fluids and secretions: Fill the Fluid Fill Unit with of
de-ionized water (approx
3 /
4
full) only and tighten the cap.
To mix simulated blood: Fill the Blood Fill bottle with de-ionized water.
Add 5-10 drops of Laerdal Blood colored concentrate, mix and
tighten the cap.
Run Manikin with External Blood
1 Drain the internal reservoir. Follow instructions for “Empty
Internal Blood Reservoir”.
2 After draining the internal reservoir, fill the blood fill unit and
connect to the manikin.
3 Push the fill button on the panel. The button will light and blood
will flow into the manikin.
4 Charge the system for 60 seconds before starting bleeding
simulation.
Warning: Connecting a full blood fill unit to a manikin with a full
internal reservoir will result in system overflow. Blood will drain out
of the right leg. Repeatedly overflowing the system may damage
the product.
Fluid
Inlet Air Out Blood Inlet Activate Filling
Fluid Inlet
Air Out Blood Inlet Activate Filling
SimMan
Blood Fill Uni t
SimMan
Blood Fill Unit
Fluid
Inlet Air Out Blood Inlet Activate Filling
Fluid Inlet
Air Out Blood Inlet Activate Filling
SimMan Blood Fill Uni t
SimMan
Blood Fill Unit
Fluid
Inlet Air Out Blood
Inlet Activate
Filling
Fluid
Inlet
Air Out Blood
Inlet Activate
Filling
SimMan
Blood Fill Uni t
SimMan
Blood Fill Unit
Fluid
Inlet Air Out Blood
Inlet Activate
Filling
Fluid
Inlet
Air Out Blood
Inlet Activate
Filling
SimMan
Blood Fill Uni t
SimMan
Blood Fill Unit
Fluid
Inlet Air Out Blood Inlet Activate Filling
Fluid Inlet
Air Out Blood Inlet Activate Filling
SimMan
Blood Fill Uni t
SimMan
Blood Fill Unit
Fluid
Inlet Air Out Blood
Inlet Activate
Filling
Fluid
Inlet
Air Out Blood
Inlet Activate
Filling
SimMan
Blood Fill Uni t
SimMan
Blood Fill Unit