Laerdal SimMan 3G Mystic - Manual (Page 16)

13 14
System Setup
Preparing for Simulation
Unpack the laptop PCs and connect them to their respective power
supplies to charge the batteries.
Instructor PC with Headset
Patient Monitor PC with Web-camera
SimMan 3G Manikin
1 Unpack the manikin torso and legs.
Assemble the legs and torso as described in Manikin Setup.
2 Fill the bleeding and fluid system if necessary. See Blood and Fluid
System.
3 Connect the manikin batteries and close the torso skin. See:
Inserting and Connecting Batteries.
4 Connect the external power supply to the manikin to charge the
manikin batteries. See: Battery Charging and Use.
5 Press the start button on the manikin. Wait until the manikin
begins breathing before switching on the Instructor PC. Start the
Instructor PC and connect the headset.
6 Start the Patient Monitor PC, if applicable, and connect the Web-
camera to the USB port of the PC.
7 Start the Patient Monitor Application software, if applicable,
attach the SPO2 probe to the patient monitor PC. See: Starting
the Patient Monitor Application.
8 Start the Instructor Application software. The application will
search for all available manikins. See: Launching Instructor Application.
9 Select a patient case in Auto Mode or pre-programmed scenario
via Instructor Mode to start the simulation.
10 The simulation system is now ready for use. Power cables may be
disconnected when batteries are charged.
Note: Also refer to the Quick Setup Guide for detailed instructions
on initial system setup.
SimMan 3G PCs
The SimMan3G simulation system includes one Instructor PC with
the pre-installed Instructor Application and one Patient Monitor PC to
simulate an actual patient monitor. The Patient Monitor PC runs the
Patient Monitor Application.
ACTIVATING THE INSTRUCTOR SOFTWARE
LICENSE
The Instructor Application license need only be activated once.
Instructor computers shipped from Laerdal Medical will have a pre-
activated license installed. Two spare licenses are provided for use on
other computers. Should the software need to be re-installed, it is not
necessary to reactivate the software license.
Activate the software via the Internet or select using
in the License key dialog box.
The SimMan 3G software comes with 3 license keys. For more
license keys please contact your local customer service office.
Activate the license manually by following the on-screen instructions.
Changes or updates of the computer hardware (e.g. new hard drive
or mother board) may render the license invalid. Please contact your
local Laerdal support for assistance for re-activating the license.
Note: Should you experience problems re-activating the
application license, contact your local Laerdal support for
re-activation