Normal operation – Labconco Protector Controlled Atmosphere Glove Boxes 5080102 User Manual
Page 21
NORMAL OPERATION
22
Start Up
• Confirm that the glove box electrical power cord is plugged into a 115 volt, 60 Hz, 20 amp
electrical power source (or 230V, 50Hz, 10 amp) as appropriate.
• Switch on the fluorescent lamp and check to make sure the bulb is working.
Operation of Controls
Pressure Control Module (Models 5070000, 5070100, 5080000 and 5080100)
A. To energize the automatic control module, actuate the pressure control power switch
located on the rear panel to the “ON” position as shown below:
REAR ELECTRICAL PANEL
Figure 12
B. Actuate the exterior outlet switch located on the front control panel to the “Auto” position
as shown below:
Figure 13
Switch to “AUTO” on
Model 50700
and
50800
This manual is related to the following products:
- Protector Controlled Atmosphere Glove Boxes 5070102 Protector Controlled Atmosphere Glove Boxes 5060102 Protector Controlled Atmosphere Glove Boxes 5080100 Protector Controlled Atmosphere Glove Boxes 5070100 Protector Controlled Atmosphere Glove Boxes 5060100 Protector Controlled Atmosphere Glove Boxes 5080002 Protector Controlled Atmosphere Glove Boxes 5070002 Protector Controlled Atmosphere Glove Boxes 5060002 Protector Controlled Atmosphere Glove Boxes 5080000 Protector Controlled Atmosphere Glove Boxes 5070000 Protector Controlled Atmosphere Glove Boxes 5060000