Dolby Laboratories Digital-Satellite-Receiver - Manual (Page 47)

8.3.3 Searching on a transponder
You can search a specific transponder (see Point 10:
Technical Terms) for available programmes. To do this, you
will have to enter the appropriate transponder data
(Fig. 8-
12) .
Satellite
In this line you must select the satellite on which the desired
transponder is located.
>
Use the
arrow keys up/down to select the line
Satellite.
> Press
OK to display a table listing the active satelli-
tes.
> Now use the
arrow keys up/down to mark the
appropriate satellite.
> Confirm by pressing
OK.
The satellite selected will now be displayed in the line
Satellite.
Transponder frequency
>
Use the
arrow keys up/down to select the line
Transponder frequency.
> Enter the appropriate frequency by means of the
numeric keys.
Symbol rate
The symbol rate indicates the volume of data transmitted per
second. A typical figure might be 27500 (27500 symbols per
second).
>
Use the
arrow keys up/down to mark the line
Symbol rate.
> Use the
numeric keys to enter the desired symbol
rate.
Polarisation
>
Use the
arrow keys up/down to mark the line
Polarisation.
> Use the
OK key in this line to enter the polarisation
plane (
horizontal or vertical) on which the desired
programme is broadcast.
Search mode
>
Use the
arrow keys up/down to mark the line
Search mode.
> Press the
OK key to decide whether you wish to
search only for free-to-air programmes (
Free
Programmes) or whether you wish to include
encrypted programmes in the search (
All
Programmes).
> Press the
red function key to confirm Start
Search.
The search will commence. Please note any messa-
ges displayed on screen.
47
(Fig. 8-12)
bed_anl_DVB13 CIP_englisch_q5.qxd 08.09.03 11:14 Seite 47