Dolby Laboratories Digital-Satellite-Receiver - Manual (Page 20)

To enjoy this feature, you must simply connect the Audio Out
Digital output (see Point 4.5.2) of your DVB receivers with the
digital input of your Dolby Digital 5.1 channel amplifier.
Where a programme is broadcast in Dolby Digital sound, this
will be indicated by the Dolby logo being displayed in the
information window when the programme is selected. If the
function Dolby Digital (AC3) is switched on, these program-
mes will automatically be reproduced in Dolby Digital format.
If the function is not enabled, Dolby Digital sound can also be
switched on manually. Please refer to Point 7.5.1 of this ope-
rating manual.
6.3.7 UHF output channel*
To set a suitable UHF output channel, proceed as follows:
>
Select a free UHF channel in the range of 21 to 69 on
your television set.
> Then, using the
arrow keys right/left set the new
output channel of your digital receiver. The digital
receiver will now transmit on the UHF channel indica-
ted on the display. If you are not able to obtain interfe-
rence-free reception on this channel, repeat the proce-
dure until you gave found a suitable channel.
> When you have found an optimum UHF channel,
remember to store this in the memory of your televi-
sion set.
> If your television set is equipped only with an automa-
tic programme scan, you will first have to set a random
UHF channel on your digital receiver, and then start
the automatic scan function of your television set. If
necessary, repeat this procedure until you have found
a suitable channel, then store this in the memory of
your television set.
> Finally, it may be necessary to perform some fine
tuning of the channel on your television set.
6.4 Antenna configuration
Once you have completed setting the digital receiver to your
individual preferences, you can proceed, if necessary, to
adjust the digital receiver settings to your antenna. The menu
Antenna Configuration contains the satellites that have
been selected in the installation assistant. If the installation
assistant was interrupted, the satellite positions ASTRA and
EUTELSAT are pre-programmed.
Should you wish to receive other satellites, or if you are using
a different type of LNC, you can adjust your digital receiver to
the appropriate data as follows:
>
Press the
Menu key to call up the Main Menu.
(Fig.
6-6)
> Use the
arrow keys up/down to select the item
Settings.
20
* Only for receivers equipped with
this feature
(Fig. 6-6)
bed_anl_DVB13 CIP_englisch_q5.qxd 08.09.03 11:14 Seite 20