Hall Research VSM-I-A-4-JA4 - Manual (Page 23)

Genesis™ Series 4x4 AV Matrix Switches
21
Command: GW xxx.xxx.xxx.xxx« stands for new Gateway address value.
Success Response: GW= xxx.xxx.xxx.xxx«
The Welcome message confirms that device has finished applying the new settings
“Welcome to the VSM-I-A matrix”
5.3.2 Loading factory defaults using Serial port on units with IP
To load factory defaults from serial interface use following command.
Command: FD«
Response: Applying Factory Defaults To Matrix- Please Wait For Welcome Message.
Wait until you see following welcome message on terminal screen.
“Welcome to the VSM-I-A matrix”
Notice User MUST enter ALL THREE Commands mentioned above with
correct values and must get ‘success response’ for each to change
IP address.
Once you have successfully entered all above commands the unit
will respond with: “Applying Settings To Matrix- Please Wait for
Welcome Message”