Hall Research VSM-I-A-4-JA4 - Manual (Page 22)

User’s Manual
20
Change Password?
Allow user to change existing password. When clicked, a new window will pop up for
entering the new password. Password length is limited to eight (8) characters long.
Apply
User must click this button after changing any field on settings tab to save changes.
Factory Reset
This button loads factory defaults to Matrix. It will reset unit to factory default values.
Factory default will also wipe out saved presets.
5.2.4 Factory Default Settings
Field Name in GUI Default Value Tab in GUI
Power Off Video
VIDEO INPUT n Vid_In_n Labels
AUDIO INPUT n Aud_In_n Labels
VIDEO OUTPUT n Vid_Out_n Labels
AUDIO OUTPUT n Aud_Out_n Labels
PRESET n PRESET_n Labels
Name VSM Matrix Settings
Location Hall Research Settings
IP Assigned by DHCP Settings
Subnet Based on IP Settings
Gateway Assigned by DHCP Settings
DHCP Enabled Settings
Login Disabled Settings
Telnet Disabled Settings
Default Password Pass Settings
5.3 IP Specific Serial Commands
HSM matrix equipped with IP interface allows user to assign Static IP address using
Serial Interface with standard RS-232. Please refer section 4 to connect PC to Matrix
over serial interface. Once you are connected use following Commands to assign IP
address or load factory defaults.
5.3.1 Change network settings of unit
Note: All commands are case sensitive. Also note that you must specify a new IP
address, followed by SB and GE commands (all 3) for the new IP to take effect
Command: IP xxx.xxx.xxx.xxx« stands for new IP address value.
Success Response: IP= xxx.xxx.xxx.xxx«
Possible error Responses: ERR! IP address not changed (if the specified IP address is
the same as unit’s existing address), or ERR! IP address is not valid. If there is a
problem with new IP address as specified
Command: SB xxx.xxx.xxx.xxx« stands for new Subnet Mask address value.
Success Response: SB= xxx.xxx.xxx.xxx«