Hall Research VSM-I-A-4-JA4 - Manual (Page 17)

Genesis™ Series 4x4 AV Matrix Switches
15
5. IP Control Basics
Figure 9 – IP Control Block Diagram
As shown in the figure above, the matrix can be controlled via RS232 Serial port or
through an IP (Ethernet) port if equipped.
The IP interface features a built-in web server allowing web browsers running on
different devices (computer, smart-phone, tablet) on the network to control and monitor
matrix through HTTP protocol on port 80. (Section 5 will walk you through this HTTP
based Web Interface). The IP interface also supports telnet connection over port
number 6324 to control and monitor matrix. (Section 6 will walk you through this telnet-
based interface)
The IP interface on every matrix shipped has a unique MAC-address, and must have a
valid IP-address to function properly on the network.
5.1 Getting Device IP Address
The VSM matrix comes preconfigured for DHCP, which means it will automatically
obtain an IP address when it is connected to the LAN. It is recommended that you set a
static IP on each system in order to guarantee it maintains the same address. In order
to set a static IP you must first discover what DHCP address was issued and then login
to reconfigure the settings.
Download and install the DeviceInstaller utility from Hall Research website. Once
installed, run the program. It will scan your LAN and locate any devices that are
connected.
Notice As shipped from factory DHCP is enabled. This means that the
network automatically assigns an IP address to your Matrix.
To find the IP address assigned to the matrix, please use Device
Installer Software to get current IP address of Matrix.
Device Installer is available on the Product’s webpage download
tab at www.hallresearch.com