Hall Research VSM-I-A-4-JA4 - Manual (Page 14)

User’s Manual
12
4.1 Routing Functions
In the following paragraphs, the symbol
«
represents Carriage Return (Hex 0D). The
*
character
is a wildcard (acts similar to DOS wildcard character)
4.1.1 Make video ties:
Command: CVn,m« Stands for Connect Video n = output, m= input
Response: CVn,m«
Note: If the input m is 0, the video output n will be blanked.
Command: CV*,m« Stands for Connect All Video Outputs to input m
Response: CV1,m« CV2,m« CV3,m« CV4,m«
4.1.2 Query video ties:
Command: CVn« Stands for Connect Video n Query
Response: CVn«
Command: CV*« Stands for Connect All Video Query
Response: CV1,m« CV2,m« CV3,m« CV4,m«
4.1.3 Make Audio ties:
Command: CAn,m« Stands for Connect Audio n = output, m= input
Response: CAn,m«
Note: If the input m is 0, the Audio output n will be disconnected/muted.
Command: CA*,m« Stands for Connect All Audio Outputs to input m
Response: CA1,m« CA2,m« CA3,m« CA4,m«
4.1.4 Query Audio ties:
Command: CAn« Stands for Connect Audio n Query
Response: CAn«
Command: CA*« Stands for Connect All Audio Query
Response: CA1,m« CA2,m« CA3,m« CA4,m«
4.1.5 Make Synchronized Audio+Video ties:
Command: COn,m« Stands for Connect both A&V n = output, m= input
Notice Almost all commands issued to the Matrix will elicit a response
once the command is accepted and execution completed. After
issuing any command, you must wait for the matrix’s response
prior to sending another command. If you send another command
prior to completion of the previous one, the matrix might ignore
the command