Dimension One Spas Sarena Bay - Manual (Page 54)

2003 Sarena Bay™
Export Owner’s Manual
Electrical System (Cont)
Symptom Problem Corrective Action
1. Check water level
2. Clean filter
If problem persists:
1. Turn off power
2. Restart the system
If problem persists:
3 flashing LEDs
appear on the
Top Side Control Possible sensor errors
Call for service
Spa lights always
start in the
default light
sequence Whenever the lights are
turned off they always
turn on in Color Fade
Fast mode Because both lights are synchronized together, they always return to a “common
starting point” after they have been turned off for more than five seconds. This
ensures that they will remain synchronized.
Water System
Symptom Problem Corrective Action
Pulsating jets Water level too low Fill with water to the bottom of the OptiMount™ located next to the Skimmer
/Filter Basket.
1. Jets are turned off 1. Turn jets on by turning jet face clockwise
2. Diverter Valve
turned
2. Turn the Diverter Valve clockwise or counter clockwise
3. Dirty Filter 3. Clean Filter
4. Air lock 4. Loosen pump union to allow air to bleed
No Jet Action,
or action is
poor
5. Gate valve closed 5. Open gate valve
1. Check water level
2. Clean filter
3. If problem continues:
a. Turn off power
b. Restart the spa
The “Check
Water
Level…..”
scrolling
message and /or
3 flashing
L.E.D.s appear
on the display. Possible sensor errors
4. If problem persists:
a. Call your dealer for service
Fountain
doesn’t drain The bottom of the
fountain has water that
will not drain out. The water level in the spa is too high. Remove enough water to return the water
level to slightly below the bottom of the OptiMount™ located adjacent to the
Skimmer/Filter Basket.
48