Dimension One Spas Sarena Bay User Manual

Page 24

2003 Sarena Bay™

Export Owner’s Manual

9. Open and remove the two bleeder valves. One is located

in the skimmer area to the right side of the Top Side
Control and the other one is located across the spa in
the UltraPure™ area on the left side of the Top Side
Control. This will allow air to escape from the pumps.

10. Remove the cap from the UltraPure™

canister and the filter basket from the Weir
Skimmer canister.

UltraPure™/Filter

Weir Skimmer/Filter

11. Then remove the

foam blocks
securing each filter.

12. Next, remove the

filters from the Weir Skimmer and
UltraPure™ canisters and fill your hot tub
by placing a hose through the empty
UltraPure™ canister on the left side of the
Top Side Control.

13. Fill the spa until the water level is slightly below the bottom of the

OptiMount™ located next to the Skimmer/Filter Basket on the right
side of Top Side Control.

14. Once the spa is full, turn on the circuit breaker (not supplied by Dimension One Spas). Flashing

dashed lines will appear for 30 seconds on the Digital Display Window followed by the current
water temperature (flashing).