Dimension One Spas Sarena Bay - Manual (Page 53)

2003 Sarena Bay™
Export Owner’s Manual
Troubleshooting Guide
Heating System
Symptom Problem Corrective Action
1. Temperature setting is
too low 1. Turn up the thermostat
2. Dirty filter 2. Clean filter
Does not heat
3. Flow switch malfunction 3. Call for service
1. Temperature setting is to
high 1. Turn down the thermostat Too hot
2. High limit tripped 2. Call for service
Erroneous
temperature of
0° C (≅32°F)or
57.8° C (≅136°F)
appears on the
display Possible temperature sensor
failure Call for service
Hot Tub
Temperature
erratic Water level Fill with water to the bottom of the OptiMount™ located next to the
Skimmer Basket.
1. Too much filtration 1. Reduce the number of filter cycles and/or the filter cycle duration
2. Temperature setting too
high 2. Turn down the thermostat
Display reads
OVERHEAT
3. High limit or sensor
problem 3. Call for service
Electrical System
Symptom Problem Corrective Action
Will not turn on
– in any mode No power Check circuit breaker and/or GFCI
Turns on by itself Normal automatic daily
power filtration, or anti-
freeze cycle No action required
Light is out Burned out bulb Replace bulb
1. Automatic timer
has shut pump off
1. Push JETS pad again to start another cycle Pump shuts
down
unexpectedly
while in use
2. Motor over-heated
and automatic
protective device
has shut down
pump(s)
2. If pump(s) will not restart when JETS pad is pushed, call for service
Make sure that the equipment panel vent area is not blocked. Vent blockage
can cause serious damage to your equipment.
47