Hall Research UHBX-SW3-WP - Manual (Page 6)

Software Guide
4
© Copyright 2015. Hall Research, Inc.
All rights reserved.
2.3.1. On/Off Control Page
The UHBX-SW3-WP Manager provides you more control and flexibility of the device than
the front panel.
Power Command Mode
For sending on/off power commands to the display, there are two different modes the
UHBX-SW3-WP device can be set to: manual and auto
 Manual – In this mode, each Power button press on the physical wall plate (or using
the Last Command dropdown from GUI) will alternate between sending the Power
On or the Power Off command to the display.
 Auto – When the device is set in this mode, it will automatically issue power
commands based on detecting video on the selected input. As soon as a video
source is plugged in to the selected input, the device will send out the pre-
configured power on command, and after video is disconnected, the wall plate will
wait for some time (typically 5 minutes), and issues the power off command.