Hall Research UHBX-SW3-WP - Manual (Page 5)

3
© Copyright 2015. Hall Research, Inc.
All rights reserved.
UHBX-SW3-WP
GUI is waiting for USB connection to wall plate
GUI has detected one device connected
2.2.2. USB Device Name
You can assign a unique USB device name to each wall plate. The device names are
stored on the wall plates. By default all wall plates are called USBDEVHR as shipped but
if you are going to configure a number of wall plates differently, then you may wish to
assign different names to them that indicates room number or configuration type.
The USB device name is shown near the top right of the screen under the toolbar. Click
to change the name. A maximum of 8 characters can be used.
2.3. Configuration Pages
There are 3 configuration pages:
• On/Off Control - can be used to:
o Define RS232 (or simple IR) commands for controlling the volume of
the display (for use with SW3-UI-VOL auxiliary keypad).
o Defining the Auto/Manual mode of Power Command
o Locking the Power Command in Auto mode
• Video - can be used to:
o Assign priorities to the 3 video inputs for Auto Source selection mode
o Defining the Auto/Manual mode of Source Selection
o Locking the Source Selection in Auto mode
o Configuring the VGA Scaler
o Configuring and monitoring the HDBaseT® output
• EDID - can be used to:
o Use an internal "emulated" or pass-thru the EDID from the display