Hall Research UHBX-SW3-WP - Manual (Page 10)

Software Guide
8
© Copyright 2015. Hall Research, Inc.
All rights reserved.
Active Video Input
The UHBX-SW3-WP has a total of three inputs : HDMI1, HDMI2, and VGA.
 HDMI1 – This input can be used for either an HDMI or a MHL source.
 HDMI2 – This input is only used for HDMI source.
 VGA – This input can be configured as VGA, component, or audio only source.
Input Switching Mode
The UHBX-SW3-WP can select inputs either manually or automatically.
 Manual – In this mode, each SOURCE button press will select the next input.
 Auto – When the device is set in this mode, it will automatically switch to an input
with the highest priority as soon as it detects its presence.
Notice When the VGA input is configured for YPbPr (component
video), Auto Source selection will not be able to detect the
source. So in this case you should not enable Auto Source
mode, and manually select inputs.
Similarly, when the VGA input is configured for Audio Only,
(can pass audio input with or without VGA connection),
then with just an audio connection (without video), the
device will not be able to automatically switch to that
input and it has to be selected manually.
Configuring the VGA input for YPbPr or Audio Only, also
will increase standby power consumption of the wall plate
and it will stay warm even if no input is connected.