Hall Research UHBX-SW3-WP - Manual (Page 15)

13
© Copyright 2015. Hall Research, Inc.
All rights reserved.
UHBX-SW3-WP
button press will trigger the unit to send any corresponding programmed serial
commands to the TV or the projector.
 Slave – In this mode, the UHBX-SW3-WP can be controlled by another device
through the UHBX-R-PSE receiver. In this mode the baud rate is fixed at 9600. The
list of supported commands in Slave mode is shown in Appendix 1.
2.5. Tool Bar Menu
The UHBX-SW3-WP Manager toolbar consists of three main menus.
File
The File menu consists of the Exit selection as shown.

Exit – Exit the UHBX-SW3-WP Manager.
Tools
 Load Configuration – Get an existing
configuration file from the PC. Configuration files
are text files that contain all user configurations
including power commands, communication
settings, auto off delay, input switching priorities,
etc.
 Save Configuration – Save the current user
configuration as a file on PC.
 Factory Default – Restore the device to factory default settings.
 Firmware Update – Allow you to update any future device firmware.
Help
The Help menu has the About selection as shown.

About… - Display the current version of UHBX-SW3-WP
Manager, device firmware, USB serial number, and UI
firmware.