beautypg.com

GoDEX EZ1100Plus series User Manual

Page 28

background image

EZ1000 Plus User Manual

24

6. Remove the cable tie from the connection

cable and extend the cable to its full

length. Now plug the cable connector into

the Ethernet module socket.

Caution

Be careful when removing the cable tie to avoid damage to the connection cable.

8. Secure the module on the printer housing

and plug the other end of the connection

cable into the socket on the motherboard.

9. Pass the connection cable underneath the

other connection cables as shown in the

illustration.

Caution

Please make sure that you position all cables in such a way that they are not

damaged when you reassemble the printer.

10. Finally, replace the top part of the printer

housing and secure it on the underside of

the printer using the screws you removed

earlier.

Note

Once you have finished installing the Ethernet module, the command "^XSET,USBETHERNET,1"

must be sent to the printer to enable the Ethernet module. While the Ethernet module is

enabled, the USB port is disabled. To enable it again, send the command

"^XSET,USBETHERNET,0" to the printer.