FeiYu Tech FY-41AP - Manual (Page 30)

Guilin Feiyu Electronic Technology Co., Ltd.
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [email protected]
Page 30
FAIL-SAFE setting
The RC receiver remote control mode uncontrolled return of function, you need
to use with runaway protection function remote and the receiver.
Failsafe remote control receiver when no signal is received, output a default set
of rudder. Various models of remote control set runaway protection have said, the
reference to the remote control manual.
Return channel CH6 need to set connected to SW2 is out of control out of control
protection switch to the status of the return. Aileron, elevator, rudder channel is set to
loose rod status, throttle setting to cruise throttle position.
If debugging balanced mode, the following Futaba remote control T10CHG
example set runaway protection. Settings, turn off the power to the aircraft, to avoid
setting the motor starts.
First enter the remote control setup menu to find the set of "F / S"; into the F / S
menu, the lever into the neutral position, rudder trimming to maintain the status
adjusted, the throttle lever to the cruise throttle position, the CH6 cut to return mode .
Then in all open channel F / S, and often set by the "PUSH" button, set successfully as
shown.
After setting the aircraft is powered off control check has successfully entered the
return mode.
Pay attention to safety, to prevent the Failsafe motor rotation, met items
cause damage.