FeiYu Tech FY-41AP - Manual (Page 19)

Guilin Feiyu Electronic Technology Co., Ltd.
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [email protected]
Page 19
Via remote control and OSD overlay menu set FY-41AP
① Activate the OSD setup menu: switch "ABM" to the "3D mode" 6 times in SW1,
between two switching it has to be less than 3 seconds, the process is as follows: ABM →
3D mode →ABM →3D mode → ABM → 3D mode → ABM → 3D mode →ABM →
3D mode →ABM→ 3D mode. This will activate OSD setup menu interface.
② Move Elevator stick to the project you want to set.
③ Move aileron stick to the project you want to set.
④ Please put elevator stick to SAVE, after your setting.Through the stick of ailerons
carried out to save the action, when saving, "SAVE" will flicker for two seconds, the end
of the flashing, been saved successfully.
NO. Setup instructions NO. Setup instructions
1 Auto-control rudder surface
reverse
10 circling radius setting
2 Control gain 11 Farthest flight distance setting
3 ailerons 12 RC mode (receiver / data
transmission radio)
4 Elevator 13 Rudder mixing mode
5 Rudder 14 Initialize gyroscope
6 Throttle 15 Record flight attitude
7 Three-switch mode selection 16 Save the settings