Eurocom Panther 5 - Manual (Page 23)

18
English
NVIDIA 3D VISION Shutter Glasses Kit
The NVIDIA 3DVISION shutter glasses kit is supported
only by models which include the built-in 3D emitter and
shutter glasses kit.
The NVIDIA 3DVISION shutter glasses kit is supplied
with a single pair of shutter glasses and all necessary ca-
bles etc. Set up the hardware (run the set up wizard as in-
dicated on
page 19 ) as instructed in the manual supplied
with the kit, however make sure you have installed the
NVIDIA driver (see
Video on page 25 ) from the Device
Drivers & Utilities + User’s Manual disc. For further de-
tails contact your service center.
Stereoscopic 3D Hardware Setup
If your computer model features a built-in 3D IR emitter
the loaction is illustrated below. The effective viewing an-
gles of the emitter are illustrated below. Make sure that
you are viewing the notebook screen within the area high-
lighted below in order to get the proper stereoscopic 3D
effect.
Figure 11 - IR Emitter Location

Important Safety Instructions
Make sure you read all the enclosed safety instructions and
precautions included in the NVIDIA 3D Vision Kit before set-
ting up the 3D Glasses and IR Emitter. Follow the setup in-
structions provided in the documentation to set up the 3D
Vision kit safely and take the “User Vision Test,” which will
initiate when you turn on your GeForce 3D Vision for the
first time. If you cannot see the image in 3D during the test,
you should DISCONTINUE USE IMMEDIATELY. Contin-
ued use may result in health-related complications.
3D Icon

USB Connection & 3D Glasses
The light on the glasses will flash amber while charg-
ing, and solid amber when fully charged.
The glasses hold approximately 40 hours of viewing per
full charge. Flashing red indicates that less than 2 hours
of charge are remaining.
The indicator light displays for about 30 seconds after
turning the glasses on.