ENMET OMNI-4000 - Manual (Page 7)

OMNI-4000 S/N 6705 and above ENMET Corporation
1
Introduction
This manual has been written to facilitate the rapid and effective use of the OMNI-4000 gas detector.
Organization of the Manual
This manual describes all the operations for which the OMNI-4000 can be used. They have been grouped in four sections:
♦ Section One:
The physical description of the instrument
♦ Section Two: Description of the use of the OMNI-4000 in the field
♦ Section Three: Maintenance, adjustment, replacement of sensors, & calibration, etc.
♦ Section Four: Detailed description of the technical characteristics of the OMNI-4000
Using the Manual
We recommend that the complete manual be read by the user. This manual has been written to provide information which
is essential to each phase of use.
To Use the Instrument Immediately
We recommend that the manual be read in its' entirety, prior to activation of the OMNI-4000. If so desired, to activate the
OMNI-4000 immediately, activate it in conjunction with this manual, refer to pages 4 to 8. This will enable you to become
familiar with the device and the features before actual use in the field.
C
AUTION : Never start the calibration procedure unless the corresponding cylinder of gas is
available. Scrolling through the calibration menu without applying corresponding
gas will cause the installed sensor to be out of calibration and showing a Fault
condition.
If instrument is new or otherwise in proper working order, this problem can only be
corrected by performing the complete calibration procedure with proper calibration gas.
Do Not Neglect To Read The Complete Manual Before Engaging In Field Use
Of This Instrument.
Illustrations
The illustrations within this manual are intended to familiarize the user with the features of the OMNI-4000 and to provide
the user with the knowledge to operate the device in a safe environment.
N OTE : All specifications stated in this manual may change without notice.
N OTE : [important information about use of instrument – if not followed may have to redo some steps.]
C AUTION : [affects equipment – if not followed may cause damage to instrument, sensor etc…]
W
ARNING
: [affects personnel safety – if not followed may cause bodily injury or death.]