ENMET OMNI-4000 - Manual (Page 61)

OMNI-4000 S/N 6705 and above ENMET Corporation
55
3.9 Changing the Date and Time
This sub-program is used to update the OMNI-4000 internal calendar and clock. This data is used to define the time
scales for the printing and down-loading to a computer of stored data.
Selecting the Maintenance Menu
Turn the instrument ON, and insert the programming plug into the DIN connector located on the side of the unit. See
Figure 3-15.
Figure 3-15: Location of Lithium Battery
N.B.: Insufficient battery voltage prevents access to the main menu. The operator is warned with a "Maintenance
Impossible" message. It is possible to continue by connecting the charger or by changing the battery pack.
Selecting the "Setting Time and Date" Menu
• The display shows:
• Press the MENU switch three times. The display shows:
• Confirm the selection by pressing ENTER
Program a
sensor
Set Date
and time
Lithium Battery