Dynavector SuperStereo Adapter Adp3 - Manual (Page 7)

SET LINE IN
Then follow steps 1-3 as in Method (2) above.
- Next connect the separate power amplifier to be used to
drive the sub-speakers to the LINE OUTPUT terminals at (12)
of the Adp-3 using the usual inter-connects.
- Then connect the sub-speakers to the sub-speakers output
terminals of the Adp-3 using speaker cable observing the
correct polarities.
- Then follow the instructions under “Listening Adjustments”
on page 8.
The method may be used when greater power is required for the sub-speakers e.g. when low sensitivity
sub-speakers are used, or the system is to be used in large rooms and at high volume.
First ensure that all equipment is turned off and the AC power cords unplugged from the wall socket.
Installation Method (3)
When using a separate power amplifier with Adp-3 to drive the
sub-speakers and the existing stereo system consists of separate
pre and power amplifiers
.
- 7 -