Dynavector SuperStereo Adapter Adp3 - Manual (Page 5)

SET SPKR
1. Keep the existing connections between your amplifier and
front speakers. Then, using speaker cables of appropriate
length, connect one end to the speaker output terminals
of your existing amplifier and the other end to the input
terminals of the Adp-3 at (7), taking care to observe the
correct polarities.
2. Select SPKS (upper) position of the Input Selector (9)
Installation Methods (1)
3. Select HIGH position of the Speaker Input Sensitivity
switch (8).
NOTE: Should the Overload Indicator blink frequently when
the Adp-3 is in use, select the LOW position instead.
4. Using speaker cable, connect the sub-speaker output
terminal of the Adp-3 (13) to the sub-speakers, observing the
correct polarities.
5. When all connections have been made and checked and
the sub-speakers placed in position, insert the AC power cord
into the unit (14).
Then follow the instructions under “Listening Adjustments” on
page 8.
Connection of the Adp-3 to a Normal Stereo System
Connection of the Adp-3 to a normal stereo system consisting of an integrated stereo amplifier and a pair
of loudspeakers. This method also covers installation for those using compact audio systems. A small
pair of sub-speakers of reasonably good sensitivity and some speaker cable is required. Ensure that the
AC power to your system is switched off and is unplugged from the wall socket. Then:
SET HIGH
Note: Where an amplifier has 2 sets of speaker output
terminals, use one set for the front speakers and the
other between the amplifier and the Adp-3 inputs at (7).
Where this is done, ensure that the amplifier speaker
switch is selected to provide output to both sets of
speaker outputs.
Twist the ends of the speaker
cables tightly, insert into the
speaker output terminals and
fasten by turning the speaker
output terminal to the right.
- 5 -