Finish plowing, 410sx operator’s manual – Ditch Witch 410SX User Manual
Page 61
Plow - 60
410sx Operator’s Manual
Operation
CMW
Finish Plowing
1.
When installation is complete, move ground drive control to the neutral position.
2.
With vibrator running, lower throttle speed and raise plow to just below ground level.
3.
Move plow vibrator control to OFF.
4.
Engage plow swing lock.
5.
Raise plow out of ground.
6.
Engage parking brake.
7.
Turn ignition switch to OFF and remove product from plow.
8.
Start tractor and drive a short distance away from work site.
9.
Shut down tractor. See page 45 for proper shutdown procedures.
NOTICE: Do not operate vibrator when plow is out of the ground. This will cause excessive
vibration and will cause rapid wear, and possible damage to the unit and product being
installed.
See also other documents in the category Ditch Witch Special machinery:
- JT5 (161 pages)
- JT922 (159 pages)
- JT9 (165 pages)
- JT20 (195 pages)
- JT1220 (201 pages)
- JT2020 (203 pages)
- JT25 (203 pages)
- JT30 (245 pages)
- JT60 (218 pages)
- JT100 (243 pages)
- AT Air Hammer (11 pages)
- TK Series Manual (61 pages)
- 8500 (77 pages)
- MR90 (121 pages)
- FT5 (28 pages)
- FM5 (57 pages)
- FM13V (46 pages)
- FM25 (67 pages)
- P80 (71 pages)
- OnGrade (63 pages)
- FX20 (100 pages)
- FX25 (119 pages)
- FX30 (149 pages)
- FX50 (141 pages)
- FX60 (157 pages)
- MV800 (111 pages)
- RT Line (115 pages)
- RT30 (97 pages)
- RT45 (203 pages)
- RT55 (177 pages)
- RT100 (161 pages)
- RT115 (252 pages)
- RT120 (223 pages)
- Zahn (105 pages)
- RT80 (203 pages)
- RT115 Q (193 pages)
- RT120 Q (211 pages)
- 100SX (50 pages)
- SK350 (77 pages)
- SK750/SK755 (81 pages)
- SK850 (107 pages)
- SK850 Footings Machine (107 pages)
- 150RT (55 pages)
- 250RT (49 pages)