Ditch Witch 410SX - Manual (Page 58)

410sx Operator’s Manual
Plow - 57
Setup
CMW
Position Tractor
1. Start tractor. See page 44 for start-up procedures.
2. Drive to starting point. Move in line with planned path. See page 45 for operating procedures.
3. Engage parking brake.
4. Lower plow blade to starting point of path.
5. Turn ignition switch to STOP.
Attach Product
To Pull Product
1. Insert material into pulling grip.
2. Tape grip with duct tape.
To Feed Product
1. Remove cable guide.
2. Feed cable through tube from top to
bottom.
3. Replace cable guide and tighten
fasteners.
4. Secure cable.
NOTICE: Keep everyone away from
material being installed.