Ditch Witch FX20 - Manual (Page 80)

FX20 Operator’s Manual
Service - 79
As Needed
CMW
Lube Blower for Long-term Storage
Lubricate blower before long-term storage to help
prevent rust and lockup.
1. Remove plug from fitting at filter.
2. Start engine.
3. Spray light oil into port and run unit for 1-2
minutes.
4. Turn off engine.
Change Blower Relief Air Filter
Check air filter whenever vacuum gauge goes
over 15” (381 mm) of mercury. Change as
needed.
1. Remove clamp.
2. Remove filter and discard.
3. Install new filter.
4. Replace clamp.
NOTICE: Operating system above 15” (381
mm) of mercury may result in blower damage.