Attach skid to trailer, Attach skid to truck bed – Ditch Witch FX20 User Manual
Page 40
FX20 Operator’s Manual
Transport - 39
Attach Skid to Trailer
CMW
Attach Skid to Trailer
Bolt skid to S4S trailer at 4 locations. Use bolt and
nut (1,2) to secure. Tighten to 200-225 ft•lb (270-
305 N•m). Install light strip to rear of tank using
bolts and nuts (3,4). Connect wiring harness from
light strip to connector (5).
Attach Skid to Truck Bed
Use indicated tiedowns to secure skid to truck
bed. Be sure to tie down both front and rear of
unit. The skid can also be bolted to a truck bed
using the 4 holes indicated above.
IMPORTANT: See parts manual for correct bolt
size and grade.
NOTICE: Use a chain, not a strap, if using the
lift/tiedown point on top of the tank.
See also other documents in the category Ditch Witch Special machinery:
- JT5 (161 pages)
- JT922 (159 pages)
- JT9 (165 pages)
- JT20 (195 pages)
- JT1220 (201 pages)
- JT2020 (203 pages)
- JT25 (203 pages)
- JT30 (245 pages)
- JT60 (218 pages)
- JT100 (243 pages)
- AT Air Hammer (11 pages)
- TK Series Manual (61 pages)
- 8500 (77 pages)
- MR90 (121 pages)
- FT5 (28 pages)
- FM5 (57 pages)
- FM13V (46 pages)
- FM25 (67 pages)
- P80 (71 pages)
- OnGrade (63 pages)
- FX25 (119 pages)
- FX30 (149 pages)
- FX50 (141 pages)
- FX60 (157 pages)
- MV800 (111 pages)
- RT Line (115 pages)
- RT30 (97 pages)
- RT45 (203 pages)
- RT55 (177 pages)
- RT100 (161 pages)
- RT115 (252 pages)
- RT120 (223 pages)
- Zahn (105 pages)
- RT80 (203 pages)
- RT115 Q (193 pages)
- RT120 Q (211 pages)
- 100SX (50 pages)
- 410SX (131 pages)
- SK350 (77 pages)
- SK750/SK755 (81 pages)
- SK850 (107 pages)
- SK850 Footings Machine (107 pages)
- 150RT (55 pages)
- 250RT (49 pages)