Corinex AV200 - Manual (Page 33)

31
Video Network Setups
Corinex AV200 Powerline Ethernet Wall Mount
4 Video Network Setups
4.1 Introduction
An In-Home AV network is made up of an access point (AP) adapter and several end
points (EPs). In-Home AV networks can have only one AP. However, several In-
Home AV networks can be created in the same space, each of them with its own AP,
because each network is isolated by a unique network identifier. An adapter can be
configured as a Fixed AP (i.e. it always will be an AP) or an automatic EP/AP. When
set to automatic, the In-Home AV protocol decides which adapter will function as
an AP. This means that if no Access Point (AP) has been defined, an End Point (EP)
will be automatically set to function as an AP.
Note: It is recommended to configure a Fixed AP. This provides increased
stability for future reconfigurations and in multi-network environments.
Note: It is not necessary to have full connectivity between all the adapters on
a network. The network topology will be configured automatically, allowing
for the use of repeaters if the connectivity between two adapters fails.
The necessary steps for setting up a basic In-Home AV network are, for each
adapter, as follows:
- Set its IP address. It should be a unique IP address (e.g. private address like
10.10.1.<pick a number>).
- Select the spectral configuration (notches enabled or disabled).
- Set
the Network Identifier. It should be the same value for all adapters on the
network.
- Configure
the Encryption Key. It should also be the same value for all adapters
on the network.
- It is not necessary to configure the In-Home AV MAC, since there is only one
available network topology in the current firmware version. To configure a Fixed
AP is optional.
4.2 Network Scenarios
This section contains a few network scenarios, explaining the application and
necessary configuration.
There are two types of In-Home AV network.