Corinex AV200 - Manual (Page 29)

27
Adapter Configuration
Corinex AV200 Powerline Ethernet Wall Mount
3.4.9 Tools
Clicking on hardware reset button will restart your adapter. The configuration will
remain the same, and any changes made in the Network Configuration section will
be applied. This means that if you’ve changed the IP address, the adapter will restart
with the new IP address.
Factory reset will restore the adapter‘s default settings. The system will ask for
the password, which is “betera“. Then click OK. The adapter will restart with the
following configuration:
- IP address = 10.10.1.69
- Configuration interface password = paterna
- Factory reset password = betera
- Device type is Automatic EP/AP
- Network Identifier is blank
- No encryption and no VLAN settings