Cino PL680BT HC - Manual (Page 68)

W
ir
eless FuzzyScan
R
efer
ence Man
ual
Configure Your FuzzyScan
60
PROGRAM
Serial Interface Control
♦ Delay Setting ♦
F_DEFAULT
Family Code Selection P.C Parameter Selection Option Code
Intermessage Delay SS
MS
None
1-99 (x10) msec
.
Scan 2 digits from the option code chart in Appendix, then FuzzyScan will terminate
this selection automatically.
FIN
(2 digits)
Intercharacter Delay SS
MS
None
1-99 (x5) msec.
Scan 2 digits from the option code chart in Appendix, then FuzzyScan will terminate
this selection automatically. FIN
(2 digits)
Interfunction Delay SS
MS
None
1-99 (x5) msec.
Scan 2 digits from the option code chart in Appendix, then FuzzyScan will terminate
this selection automatically. FIN
(2 digits)
Intermessage Delay is a time delay between messages output by FuzzyScan. Increasing this delay will help host applications process the incoming data on time.
Intercharacter Delay is a time delay between data characters output by FuzzyScan. These two parameters are used to synchronize data communication when : 1) the data
transmission speed is too fast, characters may be skipped; 2) multitasking operation system or host computers in a network may slow down the keyboard handling; 3)
various notebook or desktop PC systems require different timing parameter settings. Please always add one extra unit as safety margin when adjusting these two
parameters.
Interfunction Delay is a time delay between the transmissions of each segment of the message string.
Intermessage Delay, Intercharacter Delay and Interfunction Delay are unconfigurable under SPP and HID modes.