Cino PL680BT HC - Manual (Page 12)

W
ir
eless FuzzyScan
R
efer
ence Man
ual
Getting Started
4
Preparation before Using – Pocket Scanners
Install the Battery
Take off the battery cover from the scanner by removing two blue tapes.
Ensure the battery contacts of the battery pack are facing the charging contacts inside
the battery cavity. Then click the battery pack into the battery cavity carefully.
Place the battery cover in the right orientation onto the back of the scanner. Screw in
and tighten the four shipped M2 screws in sequence by a small screw-driver in the
clockwise direction.
Charging the Battery via Power Supply Unit
Choose the right plug and slot it into the power supply unit cavity until a “click” is heard.
Then plug the power supply unit into the wall outlet
Please make sure the USB bus power switch is in “OFF” position.
Plug the DC connector of the power supply unit into the DC Jack of the cradle. The
cradle emits four beeps. For the Smart cradle, the central indicator blinks blue once
and side indicators lights red. For the charging cradle, the central indicator lights blue.
Place the scanner onto the cradle. When the battery is fully charged, the status
indicator of scanner will light green.
Charge the Battery via USB 3.0 Port
The scanner can also be charged via the USB 3.0 port without the power supply unit.
You can connect the cradle to USB 3.0 port of host device by a USB cable, then slide
the USB bus power switch to “ON”. After that, place the scanner onto the cradle.
The scanner can also be charged via its micro USB port by connecting the micro USB
cable to USB 3.0 port of host device or the commercial USB power adapter connected
to the wall socket.